When 802.1X config is applied to the port I can no longer see the MAC address on the interface. When config is removed the MAC address shows up on the port. After applying the config I have bounced the port and the device however it still does not show up unless I remove the config. Since the port never gets the MAC address we are not able to authenticate the port using MAB. Here is the config applied to the port.
description DOT1X
switchport access vlan 999
switchport mode access
switchport voice vlan 218
switchport priority extend trust
no logging event link-status
no logging event power-inline-status
cdp enable
authentication event server dead action authorize vlan 216
authentication event server dead action authorize voice
authentication host-mode multi-domain
authentication order dot1x mab
authentication priority dot1x mab
authentication port-control auto
mab
no snmp trap link-status
dot1x pae authenticator
dot1x timeout server-timeout 30
dot1x timeout tx-period 10
dot1x timeout supp-timeout 15
no mdix auto
spanning-tree portfast
This is a 9248 switch running 16.9.4.
