cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
489
Views
0
Helpful
2
Replies

871 router configuration

lp10239309
Level 1
Level 1

New to this chat, would like to get suggestions from you about configuring my 871 router. I have FiOS, with action tech router, in the house and want to connect my Cisco router to it and get to the Internet. I can ping Yahoo from the router but still cannot hook my PC to the router and get out. I would like to do this so I can start getting hands on for the ccent. Any leads or help would be greatly appreciated thank, Larry

2 Replies 2

Philip D'Ath
VIP Alumni
VIP Alumni

Check out this config wizard of mine.  It will do most things for you.

http://www.ifm.net.nz/cookbooks/800-isr-wizard.html

Dennis Mink
VIP Alumni
VIP Alumni

configure the WAN interface  on your 871 to be in the subnet that your action tech router is  in, and then, on the LAN side of your 871, configure a new subnet that you want your end points to be in.

the default gateway on your 871 should point to your action tech router and the default gateway for your LAN endpoint should be the IP address of the 871 routers LAN address (interface vlan 1 off the top of my head)

Please remember to rate useful posts, by clicking on the stars below.