03-08-2022 02:31 PM - edited 03-08-2022 02:39 PM
Hi, I got the below question. The switch is WS-C3560E-48TD 12.2(50)SE2
And I want to add access-list. Do you think it would be fine after changing NTP into digit number? Looks like the switch does not support name extended acl? Thank you
ABC(config)#ntp access-group serve-only NTP
^
% Invalid input detected at '^' marker.
ABC(config)#ntp access-group serve-only ?
<1-99> Standard IP access list
<1300-1999> Standard IP access list (expanded range)
03-08-2022 03:01 PM
Yes, I am sure there is no problem; Named ACL or numbered ACL, operations are the same; just looks a bit different.
Regards, ML
**Please Rate All Helpful Responses **
03-09-2022 12:11 AM
check below commands : if the WORD not exists there, you need to use access-list number only rather name
03-09-2022 12:46 AM
In reading the original post I notice especially this part " Looks like the switch does not support name extended acl?" What the switch does not support is extended acl. A named acl should be fine - as long as it is a standard acl and not an extended acl.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide