02-15-2007 06:23 AM - edited 03-05-2019 02:22 PM
Hi,
I am a newbie in this forum.. Can you please tell me whether I can specify a range of ports from the Public IP to the Internal servers. Normally the F5 does not allow you to add range of ports for a mapping..
Thanks
Shyam
02-15-2007 08:25 PM
Hi Shyam
If you are asking about doing the static port translation in your Cisco box ofcourse its possible to do the same.
you can refer the below link to get started..
http://www.cisco.com/en/US/tech/tk648/tk361/technologies_white_paper09186a0080091cb9.shtml
regds
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Log in to Community