Applying Service-Policy On Interface Of 3850??

[d.kepmegni]

Hi

I am working on 3850 switches and need to config QoS. I do realize that it doesnt support mls qos anymore and was following the IOS based qos where I created ACL, followed by class-maps and finally tried to use service-policy on the interface to apply the QoS. But for some reason, that doesnt get appied.

Initially I used range commad to apply on a set of interfaces, that time it gave me an error saying cannot execute the command. Following this, i applied on a single int, this time no error shown, however, when i do sh run int gx/0/x...or sh policy-map int gx/0/x....it doesnt show me service-policy applied.

Has anyone seen this issue?

I am runniing cat3k_caa-universalk9.SPA.03.06.03.E.152-2.E3.bin version on the sw.

Regards,

[Smitty83]

I'm experiencing the exact same issue on my 3850 running IOS 3.7.  I follow all the instructions in the 3850 configuration guide but after issuing the service-policy output command it doesn't reflect as being applied in the running config.