Interface 2 is intended to have 3 subnets : 10.1.0.x,10.2.0.x,10.3.0.x
SNAT rules are in place for each of the subnets to have traffic to the 192.168.x.x. IPs on int2 as well as reciprocal rules from int1.
Same security level trafic is enabled between interfaces and if I set the devices to 10.0.0.x addressing, versus the subnet10.1.x.x, traffic flows fine. It appears tha for some reason it is not possible to have multiple subnets communicating.
I have tried creating all shapes and forms of dynamic as well as exempt rules in the NAT tables.
The packet testing shows that flow is good and should be working, but there is actually no traffic.
At this point I have xhausted my knowledge base and would like to ask how this should be findamentally configured.
You feedback is immensely appreciated. My apologies if this isn't the right forum to post in, but I felt it was appropriate due to it being a routing issue.
Cisco 2509-RJ freezes during start-up I bought some Cisco 2509-RJ terminal server to work on my labs and was working fine. Today I turned it on and half way through starting up it seems to freeze. I can only find one instance of this happing to ...
Cisco Digital Network Architecture Center Modules(Design Module)Part.2In this article, we are going to talk about the Cisco Digital Network Architecture Center design Module. Cisco DNA Center gives us the flexibility and availability to con...
Connectivity Design considerations and recommendation
1.Management Access connectivity
If there is a dedicated OOB management path, consider connecting to CIMC and MGMT port.
If OOB path is not available, Connect the dedicated Management port to LAN Swi...
Cisco Digital Network Architecture Center Modules In this article, we are going to talk about Cisco Digital Network Architecture Center design Module. Cisco DNA Center gives us the flexibility and scalability to configure multiple fabric sites a...