ASA Load balance Question

[tbarberio]

On a cisco ASA is it possible to load balance between 2 ISP links? Or is that not supported.

Basically have an ASA load balance MPLS connections or is this not going to work and they have to use a router? meaning want both MPLS connections active for LB and redundancy in case ones fails. Can this be accomplishes in ASA devices or have to go to a router for this?

If not possible in an ASA can I make one of the links NON active for auto failover i realize then I would have no LB but at least some redundancy.

[ALIAOF_]

Check out this link that I saved, hope this helps:

https://supportforums.cisco.com/docs/DOC-15622

https://supportforums.cisco.com/docs/DOC-13015

[tbarberio]

Ok this was very helpful

But 2 questions remain after reading both.

1. If isp#1 fails will it faill all traffic over to ISp#2?

2. Will the workaround in doc15622 only work below a certain code version?

[ALIAOF_]

You can use the track and sla monitor option:

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a00806e880b.shtml

[Abzal]

Hi,

As far I know ASA does not support load balancing but I'm not sure about the latest versions.
https://supportforums.cisco.com/thread/2050087

I think it's better to use routers instead of ASA.

Sent from Cisco Technical Support Android App