ASR-1002

[Chrispaul84]

Hello,

I need to know, can i create svi on the ASR 1002 ?

Regard

Chris

[InayathUlla Sharieff]

Hi Chris,

We have bridge domain groups and BDI interfaces (instead of

Vlan, SVI interfaces), please see the same below:

http://www.cisco.com/en/US/docs/routers/asr1000/configuration/guide/chas

sis/bdi.html

Few points:-

1. Legacy bridging is not supported on ASR1k. Please see: CSCth68125 ASR1k : Remove unsupported command

'bridge-group' from the parser.  The commands were 'bridge-group ...' and 'interface BVI'.

2. The only solution is BDI.  The support for the same started from:

XE32/15.1(1)S/3.2.0S.

Please also be noted that you are running an IOS-XE software that's quite old and end of software engineering as well:

End-of-Sale and End-of-Life Announcement for the Cisco IOS XE Software Release 2.4

17/Feb/2010

HTH

Regards

Inayath

Please rate useful posts and remember to mark any solved questions as answered. Thank you.

[Bilal Nawaz]

Hello Inayath,

I also had a similar query a while ago. But using the bdi interface I could never get an ospf neighborship to form properly, because I had the service instance on the trunk interface. It was double tagging my traffic and broke OSPF.

Instead I ended up using sub-interfaces and some service instances too.

Do you know why the ASR provides an option to create a vlan and an SVI? Will this be supported in future?

Thank you

Sent from Cisco Technical Support iPhone App