Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results forĀ 
Search instead forĀ 
Did you mean:Ā 
cancel
Start a conversation
494
Views
0
Helpful
2
Replies

BFD on etherchannel running OSPF

maliha_fayyaz
Level 1
Level 1

ā€Ž08-31-2016 02:53 AM - edited ā€Ž03-08-2019 07:14 AM

we have  'WS-C6509-E' in core (VSS) connected through fiber and running OSPF on ether channel . I want to configure BFD but the option is not available under the interface port channel command. It is available under a single interface and ospf routing process command. The version running on switches are  Cisco IOS Software, s2t54 Software (s2t54-ADVIPSERVICESK9-M), Version 15.0(1)  RELEASE SOFTWARE (fc4).

Any suggestions why bfd option not available under ether channel interface

Labels:
0 Helpful
2 Replies 2

Pawan Raut
Level 4
Level 4

ā€Ž08-31-2016 03:01 AM

  • Port-channel configuration limitations are as follows:

    • For Layer 3 port channels used by BFD, you must enable Link Aggregation Control Protocol (LACP) on the port channel.

    • For Layer 2 port channels used by SVI sessions, you must enable LACP on the port channel.

  • BFD is supported on SVI interfaces that are formed over virtual port channels (vPCs), vPC peer-links and FabricPath links.

0 Helpful

maliha_fayyaz
Level 1
Level 1
In response to Pawan Raut

ā€Ž08-31-2016 04:13 AM

can we run bfd on interface vlan

0 Helpful
Customers Also Viewed These Support Documents