cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
428
Views
0
Helpful
2
Replies
Highlighted

Bringing a New 3560 UP

Hi,

I am sorry if I'm posting a silly question in such a big forum...

Can someone please let me know / correct my procedure to install and bring UP a new switch into the network ???

1. Baremetal switch - Power ON and connect to console via Putty or any other way..

2. Cisco Switches will have their FLASH empty when they are fresh out of the factory.. Load IOS.

3. Reboot the switch which will initiate setup wizard.

4. Give the IP address for the switch

5. Change the Switch's VTP mode as Trasparent and domain settings

6. COntinue to configure the switch for other custom settings.

Thanks,

Bala..

Everyone's tags (3)
2 REPLIES 2
Highlighted
Hall of Fame Community Legend

Bringing a New 3560 UP

Uhhhh ... No. 

A bit stupid, for a company like Cisco, to sell an appliance without an OS.

Highlighted
Contributor

Re: Bringing a New 3560 UP

This would work but I would not use the wizard. Everything by command line.

Conf t
Int vlan 1
Sh
End
Vlan data
Vlan 10 name users
Vlan 20 name servers
Vlan 30 name management
VTP mode trans
Apply
Exit
!
Conf t
Ip routing! If required
.....


And so then you just assign the interfaces you need to the vlan you want to work with.
I believe that a

Show flash:

should tell you more about what you have/had on your switch.


Alessio

Sent from Cisco Technical Support iPad App

CreatePlease to create content
Content for Community-Ad