ā04-16-2017 05:30 AM - edited ā03-08-2019 10:12 AM
Hii ,
Is any one tell me that how to recover the switch from brom mode . If there is good and experienced solution is available then let me know .
Thanks ,
ā04-16-2017 05:33 AM
Hi
If you have still contract, a case should be opened with the Cisco TAC.
https://supportforums.cisco.com/discussion/12251826/brom-boot-2960xr-switch
ā04-16-2017 05:34 AM
Dear Julio ,
my issue is still persist and i want urgent solution on it .
ā04-16-2017 05:40 AM
dear Julio ,
I have checked the link which you are mentioned above but on that no solution is available .I believe that there is a solution available to recover the switch from brom but i am not able to get yet .
ā04-16-2017 05:48 AM
Hi
Unfortunately is the only information I have found. Could you please share the complete error message. Apparently it is a hardware failure, you could reach the Cisco TAC in order to open a case
https://supportforums.cisco.com/discussion/12483316/catalyst-2960-x-not-booting-showing-brom-prompt
ā04-16-2017 06:21 AM
Dear Julio,
I am very thanks full to you that sharing your input .....
Thanks
ā04-16-2017 06:27 AM
It was a pleasure my friend.
:-)
ā04-16-2017 06:53 AM
Raise a TAC Case and get the appliance RMA-ed.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide