04-16-2017 05:30 AM - edited 03-08-2019 10:12 AM
Hii ,
Is any one tell me that how to recover the switch from brom mode . If there is good and experienced solution is available then let me know .
Thanks ,
04-16-2017 05:33 AM
Hi
If you have still contract, a case should be opened with the Cisco TAC.
https://supportforums.cisco.com/discussion/12251826/brom-boot-2960xr-switch
04-16-2017 05:34 AM
Dear Julio ,
my issue is still persist and i want urgent solution on it .
04-16-2017 05:40 AM
dear Julio ,
I have checked the link which you are mentioned above but on that no solution is available .I believe that there is a solution available to recover the switch from brom but i am not able to get yet .
04-16-2017 05:48 AM
Hi
Unfortunately is the only information I have found. Could you please share the complete error message. Apparently it is a hardware failure, you could reach the Cisco TAC in order to open a case
https://supportforums.cisco.com/discussion/12483316/catalyst-2960-x-not-booting-showing-brom-prompt
04-16-2017 06:21 AM
Dear Julio,
I am very thanks full to you that sharing your input .....
Thanks
04-16-2017 06:27 AM
It was a pleasure my friend.
:-)
04-16-2017 06:53 AM
Raise a TAC Case and get the appliance RMA-ed.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: