Hi, I just got an old WS-C2960X-48LPS-L which has the four SFP ports. Every spec sheet says they're only 1gb SFP ports but for some reason when I run sh version it lists "2 Ten Gigabit Ethernet Interfaces." I was surprised to see that and thought it was the stacking ports so to rule that out I removed them and it still said it has 2 10gb ports. I'm not sure which to believe at this point or can someone tell me what its referring to? I'll post the info below:
cisco WS-C2960X-48LPS-L (APM86XXX) processor (revision M0) with 524288K bytes of memory.
Processor board ID FOC2030S208
Last reset from power-on
1 Virtual Ethernet interface
1 FastEthernet interface
52 Gigabit Ethernet interfaces
2 Ten Gigabit Ethernet interfaces
The password-recovery mechanism is enabled.
512K bytes of flash-simulated non-volatile configuration memory.
Base ethernet MAC Address : XX:XX:XX:XX:XX:XX
Motherboard assembly number : 73-16692-05
Power supply part number : 341-0528-02
Motherboard serial number : XXXXXXXXXXX
Power supply serial number : XXXXXXXXXXX
Model revision number : M0
Motherboard revision number : A0
Model number : WS-C2960X-48LPS-L
Daughterboard assembly number : 73-14200-03
Daughterboard serial number : XXXXXXXXXXX
System serial number : XXXXXXXXXXX
Top Assembly Part Number : 68-100470-02
Top Assembly Revision Number : B0
Version ID : V04
CLEI Code Number : CMMLP00ARD
Daughterboard revision number : A0
Hardware Board Revision Number : 0x18
Switch Ports Model SW Version SW Image
------ ----- ----- ---------- ----------
* 1 54 WS-C2960X-48LPS-L 15.2(7)E8 C2960X-UNIVERSALK9-M
