C9200L-48P-4x DATA stack an not power

[Clem58]

Hello,

Could you please confirm the C9200L-48P-4, like other C9200 or C9200L can do only DATA stack (StackWise) with C9200L-STACK-KIT, and this not possible to have power stack ?

Do you have any Cisco document that specifically mentions that ? I cannot find.

Many thanks by advance for your help.

[M02@rt37]

Hello @Clem58 

Documentation talk about data stack _ no power stack fort that model.

--

https://www.cisco.com/c/en/us/support/docs/switches/catalyst-9300-series-switches/217684-verify-and-troubleshoot-stackwise-on-cat.html

[pieterh]

from own experience i can tell it does not support stack-power

if you need document to "prove" this look at the 
hardware installation guide and achitecture whitepaper, that  do not mention anything about stack-power

https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9200/hardware/install/b-c9200-hig/installing_the_switch.html

https://www.cisco.com/c/en/us/products/collateral/switches/catalyst-9200-series-switches/nb-06-cat9200-architecture-cte-en.html

if it did support, it would definively be mentioned in those documents

[Jens Albrecht]

Hello @Clem58,

you will not find Cisco documentation talking about features that are NOT implemented.

So if you search for a specific feature and cannot find it in the documentation for a platform, then this typically means that this feature does not exit on that platform.

You cannot find any information about power stacking on the Catalyst 9200L platform?
You guess it, this feature is not supported on this platform.

HTH!

[julian.bendix]

Can confirm too, it doesn't support it.

[lpenadav]

Hello Clem58, 

StackPower is not supported on Catalyst 9200 or Catalyst 9300L series switches

You can refer to the document below for more information on configuring and troubleshooting StackPower.

https://www.cisco.com/c/en/us/support/docs/switches/catalyst-9300-switch/217759-configure-and-troubleshoot-stackpower-an.html