Hello,
On a C9300-24S, I will need to remove the second BGP peer that will be obsolete after a core switch refresh in the remote site.
I will execute :
no neighbor x.x.x.x peer-group pgroupname
on the corresponding router bgp ASNWill I need also to ...
Hello,We will replace soon 2 C4500 by 2 C9400 chassis.Currently we have HSRP set and root guard on the uplinks of both core switches. But for my side using root guard will indeed prevent any access switches to take the root place, but it can also blo...
Hello,I have installed a stack of 2x C9300X-24Y and 2x C9300-48P.Config has been done successfully, and the interfaces appear normally using "show int status".But when I execute "show int desc" I can see some unwanted ports in the list, that are actu...
Hello,We have configured a new CBS250-8T-D Cisco Business 250 series, but we cannot see any TACACS settings for this device, only Radius, while on the specs and the help it's mentioned we can configure TACACS.Do you have any info on this ?Many thanks...
Hello,We have a WLC 9800-CL on 17.9.3 code, APs are running in flexconnect.I'm testing a 9120AXI AP, I have implemented WIFI6 802.11ax and tested on one Dell laptop, It's showing 1633/1922Mbps, DL/UL. Anyway it's limited by the switch port speed wher...
Many thanks.
Sorry but I forgot to mention this is the second peer of a peer-group, we have another peer we need to stay connected/activated in this same group, but I'm afraid if we do
no neighbor x.x.x.x activate it will remove route-map
and config ...
.png "Hall of Fame"){kind=icon}
