ā09-02-2024 05:16 PM
I have a 2960 Cisco Series Switch can access privilege mode. Then unable to access the switch in configuration terminal command. How can i get back into config T mode so, can change the configuration of the switch.
ā09-02-2024 05:30 PM
You can nagivate from privilege mode to configuration terminal by using the command "config t" and you can return to privilege mode by using the command "exit".
ā09-02-2024 05:33 PM
I agree that is how it should work. when type the command "config T" nothing happens! It just stays in privilege mode.
ā09-02-2024 06:09 PM
Can you send a print?
Are you using local user or tacacs user?
ā09-02-2024 06:45 PM
using tacacs user
ā09-02-2024 06:50 PM
A tacacs user can have specific command restrictions.
Even without tacacs, if you're not priv lvl 15, commands can be restricted too.
ā09-02-2024 11:44 PM
Can yoh share config
MHM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide