Can't get into Router(config-if-ssid)# mode

[ronins9720]

I am using 2811 router on packet tracer software to establish a wireless connection between router and laptop. I am not able to access Router(config-if-ssid)# mode. After assigning ssid the configuration mode does not change to (config-if-ssid) from (config-if) as shown below.

R3(config-if)#int Dot11Radio0/3/1

R3(config-if)#ssid cisco

R3(config-if)#

%LINK-5-CHANGED: Interface Dot11Radio0/3/1, changed state to administratively down

%LINEPROTO-5-UPDOWN: Line protocol on Interface Dot11Radio0/3/1, changed state to down

%LINK-5-CHANGED: Interface Dot11Radio0/3/1, changed state to up

%LINEPROTO-5-UPDOWN: Line protocol on Interface Dot11Radio0/3/1, changed state to up

R3(config-if)#

[Georg Pauwen]

Hello,

post the zipped Packet Tracer (.pkt) project file, so we can see which modules you have installed in the 2811...

[ronins9720]

Thank you for your reply. Please find attached file of my project.

[fosterannan]

Please has this issue been resolved