(cat4500e-ENTSERVICESK9-M), Version 12.2(54)SG1 supports QoS

[mohit.chauhan]

Hi guys

Does this software image supports QoS? If not, can you guide me which is the best one to use?

I am having 4500E Sup 6L switch.

Thanks!

[mohit.chauhan]

My fault there-

It deos accepts QoS but cos I was migrating the config from a different model switch, it did not like few commands which in turn made me feel suspicious.

To share that info exactly,

i was trying to run the following commands :

mls qos map cos-dscp 0 8 16 26 32 46 48 56

mls qos srr-queue input bandwidth 90 10

but it did not like mls...

I am trying to get the right syntax for that now...shall keep posted.

[sbhadrav@cisco.com]

Release 12.2(54)SG1 provides the following new hardware on the Catalyst 4500 series switch:

Catalyst 4948E-F—The Catalyst 4948E and Catalyst 4948E-F share the same internal hardware and software. The Catalyst 4948E draws cold air into the port side and exhausts hot air on the power supply side. The Catalyst 4948E-F draws cold air at the power supply side and exhaust hot air on the port side. This is the only difference between the Catalyst 4948E and the Catalyst 4948E-F.