Catalyst Express 500 Series - Not able to configure

[engineer_msu]

Hi All,

I am trying to configure the "cisco express 500" switch but getting the recovery page, which is giving three options, i tried all the three options but I am not able to get the configuration menu and getting the recovery menu all the time. I have attached the snapshot of the menu i am getting. Please help.

[Ganesh Hariharan · Accepted solution]

Hi All,
I
am trying to configure the "cisco express 500" switch but getting the
recovery page, which is giving three options, i tried all the three
options but I am not able to get the configuration menu and getting the
recovery menu all the time. I have attached the snapshot of the menu i
am getting. Please help.

Hi,

Try to configure to reset the Catalyst Express 500 Series Switches to Default Factory Settings then configure,check out the below link hope it help out your query !!

http://www-europe.cisco.com/en/US/products/ps6545/products_tech_note09186a0080707fb0.shtml

If helpful do rate the valuable post.

Regards

Ganesh.H