cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
789
Views
5
Helpful
2
Replies

Cisco 1811

Gary Lefebvre
Level 1
Level 1

Hello,

can someone explain how to properly use both the ip interfaces and the switch interfaces on the Cisco 1811. I have tried to set the router up with vlans on the switch portion and ip addresses on the ip interfaces. That isn't the problem. When I try to communicate between the switch portion and the ip interface portion, I don't get the communication that i thought I would get. Is there something I need to understand? Because I can use two separate devices, (router and switch) and get the results that I need but not with the integrated device of the 1811.

1 Accepted Solution

Accepted Solutions

Joseph W. Doherty
Hall of Fame
Hall of Fame

Likely you need to define SVI(s) for your switch ports.

View solution in original post

2 Replies 2

Joseph W. Doherty
Hall of Fame
Hall of Fame

Likely you need to define SVI(s) for your switch ports.

B.kablawi90
Level 1
Level 1

Hello,

You have to define sub-interfaces toward the switch using the SVI and define a sub-interface for each VLAN with dot1q encapsulation.
Share your topology if you need any further assistance.

Wish you the best luck