cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2942
Views
0
Helpful
5
Replies

Cisco 2955 - Send config changes to syslog server?

Andy White
Participant
Participant

Hello,

I can't seem to send config changes to our syslog server on a 2950, I'm fine with 2960's and 3750's.  The Cisco 2955 is using the latest IOS

c2955-i6k2l2q4-mz.121-22.EA14.bin.

Here is what I have added:

logging buffered 64000 debugging

logging console informational

logging monitor informational

logging facility local4

logging source-interface Vlan10

logging 172.21.1.3

logging synchronous

logging synchronous

          

The only sylog message I get is "Configured from console by username on vty0 (10.1.1.35)

Any ideas

5 Replies 5

John Blakley
Advisor
Advisor

Andy,

I'm not sure if this will fix your issue, but try "logging userinfo"

HTH,

John

HTH, John *** Please rate all useful posts ***

This is all I get:

#logging ?

  Hostname or A.B.C.D  IP address of the logging host

  buffered             Set buffered logging parameters

  cns-events           Set CNS Event logging level

  console              Set console logging level

  exception            Limit size of exception flush output

  facility             Facility parameter for syslog messages

  file                 Set logging file parameters

  history              Configure syslog history table

  monitor              Set terminal line (monitor) logging level

  on                   Enable logging to all supported destinations

  rate-limit           Set messages per second limit

  source-interface     Specify interface for source address in logging

                       transactions

  trap                 Set syslog server logging level

Jeff Van Houten
Contributor
Contributor

You need to set the trap level. Set logging trap notify.

Sent from Cisco Technical Support iPad App