Cisco 2960 Switching port-security aging static does not delete static mac

[Gruvz]

Good afternoon, I'm just starting to learn Cisco, and I had a question about Port Security.

I have physical hardware Cisco 2960 Version 15.2 (2) E7

I configured the port fa0/3 and I just can't figure out what should happen in 1 minute.

Do I understand correctly that the static MAC address should be removed from the configuration after 1 minute after I turn off the laptop?

interface FastEthernet0/3
switchport mode access
switchport port-security mac-address e4e7.493f.bf10
switchport port-security aging time 1
switchport port-security aging static
switchport port-security

After 1 minute, I observe the same

interface FastEthernet0/3
switchport mode access
switchport port-security mac-address e4e7.493f.bf10
switchport port-security aging time 1
switchport port-security aging static
switchport port-security

[paul driver]

Hello
After 1 min the  mac-address of that static entry will be flushed and be relearned.
The only time this wont occur even with mac aging is when you had a mac-address sticky applied to the port.