cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
415
Views
0
Helpful
1
Replies

Cisco 3750, how do I cap bandwidth?

Isaac_Abram
Level 1
Level 1

Hi All,



I have use the following commands to limit my bandwidth to 50 percent.

enable>Configure terminal>interface gigabitethernet1/0/1>srr-q

ueue bandwidth limit 50


Now I verified that it took affect by seeing by running show Ip interface brief and it is listed on the interface, However it does not take affect. It still runs at maximum speeds.


The Troubleshooting steps I took : I was trying to add an IP address statically to the interface and got an error (please refer to the attachment)

1 Reply 1

acampbell
VIP Alumni
VIP Alumni

Isaac,

To configure your ip address on the interface try this :-

!

int g1/0/1

shut

no switchport

ip address 192.168.0.50 255.255.255.0

no shut

!

Regards,
Alex.
Please rate useful posts.

Regards, Alex. Please rate useful posts.
Review Cisco Networking for a $25 gift card