Cisco 4403e Boot Problems
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-15-2012 06:18 AM - edited 03-07-2019 06:42 AM
I am new to this and have ran into some problems. I butilt up my router I was able from the rom> prompt to get my router to boot from SLOT0:xxxxx
Then I did the copy command copy slot0:xxxxxxx bootflash:xxxxxxx
My router starts up fine. I did all my configurations and did my copy run start when I was done. As this is what I do on my 3750s.
My router lost power and rebooted and I lost everything it did not boot up to my last configuration.
How do I save my configurations when I am done ?
How do I get it to boot from that configuration every time?
- Labels:
-
Other Switching
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-15-2012 04:35 PM
How do I save my configurations when I am done ?
Command: wr
How do I get it to boot from that configuration every time?
Save the config using the "wr" command. Everytime the router boots, it will always boot the startup-config file found in the NVRAM (command: dir nvram:).
