Cisco 9300 - HTTP/HTTPS doesn't work. Help

[mik31]

So I've enabled HTTP and HTTPS.

I'm able to get to the login page and login. However it takes me to what you would think the main dashboard/website but I only see the Cisco logo and the back button.

I've ran a debug ip http and I am getting the following error. If HTTPS is on or off.

HTTP:Enable sock read

[Reza Sharifi]

Can you post the output of "sh run"?

HTH

[briankk1582]

Did you try a different browser at all?

[mik31]

Yes multiple browsers.

I should add I tried another switch which is a 9200 that behaves the same way at this site.

[Leo Laohoo]

The the switch offline (off the network) and connect the PC to this switch and see if it works. 

[Leo Laohoo]

Depending on the firmware version, try a different browser, particularly older browser versions.

[marce1000]

 - Upgrade to advisory software version (if applicable) : https://software.cisco.com/download/home/286315874/type/282046477/release/Amsterdam-17.3.4 . check if that can help.

 M.