Hello,
I'm not an everyday networking guy - but have been taksed with getting these ready for an install. Our firm has some "templates" we use to help me along bu thtey are fo rthe model without the "S" at the end. Firmware needs to be at 12.2 (58) SE2 for special reasons.
I have 4, two are to be Level 2, two are to be Level 3. Each has 24 ports, plus 2 RJ45 GIG ports and 2 Fiber Ports.
Questions are:
The Level 2's need to use the fiber to connect long distance to one unit.
- What shoult the trunking ports on these be? 23 & 24? Forget the 2 GIG prots for trunking as one is used for something else?
- What would be the time zone for California / Cisco wise?
There's a lot more questions on this - but this is my starting point. I apologize that I'm not up on this, hope you'll provide some slack / time :-)
Thank you ...
