Cisco ISE cpl configuration remove

[ironman28]

I have a stacked Cat 9300 switch, it is configured with ISE cpl.   Doing search shows that it is not reversible.  Can we factory reset the Catalyst switches so that we can go back to the legacy configuration?  If yes, how do I factor reset the switches. 

Thank you.

[Flavio Miranda]

factory-reset all

Done!

[ironman28]

This will remove the cpl?  When you do factory-reset all, does it bring the switch back to the way it was shipped?  

[Flavio Miranda]

Honestly, never had to use but according to doc, see what happens on the print attached

[ironman28 · Accepted solution]

Thank you.   I will have to try it. 

[ironman28]

That factory reset reverted back to the legacy mode. 

Thank you!