Cisco Router 2800 HWIC-1ADSL

[AMIR ELGAMMAL]

Hi Guys ,

I have Big problem since last week !

I installed HWIC 1ADSL on my router but when i try configure it i can't show interface on router !

Please anybody can help me urgent.

Thanks so much

[Leo Laohoo]

Most likely you are running the wrong IOS.

You need a minimum of 12.4(4)T.  Take particular attention to the "T" train.  If you are not running the "T" train, you're not running the right IOS at all.

ADSL2 and ADSL2 High-Speed WAN Interface Cards

Software Support
The 1-port HWICs are supported starting the 12.4(4)T and 2-port HWICs are supported starting the 12.4(6)T. The Annex-M HWIC is supported starting 12.4(11)XW.

Please don't forget to rate our useful posts.  Thanks.

[AMIR ELGAMMAL]

Thanks you for your prompt reply , This my ios ver.

c2800nm-advipservicesk9-mz.124-7a

[Leo Laohoo · Accepted solution]

c2800nm-advipservicesk9-mz.124-7a

As I mentioned in my previous post, you need the "T" train.  Your IOS may be correct, i.  e.  12.4(7), but the train is incorrect.  Download an IOS with the "T" at the end.

[AMIR ELGAMMAL]

Excuseme. I have ios ver.

c2801-entbasek9-mz.151-3.T.bin , when i try copy to router by TFTP , this message apear

%Warning: File not a valid executable for this system

[Leo Laohoo · Accepted solution]

%Warning: File not a valid executable for this system

The IOS you downloaded could either be corrupted or not complete.

Please verify the following:

Size: 34809.93 KB (35645364 bytes)

Minimum Memory: DRAM:256MB   Flash:64MB

[Leo Laohoo]

Thanks for the ratings.

Hope this helps.

[AMIR ELGAMMAL]

I still wait for replay regarding above message (

%Warning: File not a valid executable for this system

)

[Leo Laohoo]

I still wait for replay regarding above message (
%Warning: File not a valid executable for this system
)

Please be patient.  I'm not being paid to do this and I do this during my free time.

Besides, I've already responded to your previous post.