cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
376
Views
0
Helpful
1
Replies

Cisco Virtual Stack

Hi,

We have 3850 virtual stack switch. the stack formation is over 10 gig and 1 gig as dual active detection link.


Stack is fine and formed correctly as per the outputs. But when we reload the switch the stack fails. Basically the switch reboots, boots the ios and detects as switch 2 and goes to for initialization and then it gets stuck. then reboots all over again.


We are not able to find out why this is happening.


Has anyone seen this behavior.

1 Reply 1

Leo Laohoo
Hall of Fame
Hall of Fame

@saxenanitesh8522 wrote:

But when we reload the switch the stack fails.


CSCvj73842

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco