conection problems between cisco Fabric Interconnect 6324 an cisco MDS 9148

[jmanriquel]

I have a problem with cisco FI 6324 and MDS 9148S, the MDS did no see any wwwn.

the mds is configured in NPIV mode

the MDS have a vsan created (Vsan 99)

the fi have 2 vhba configured in VSAN 99,100

the fi fc ports are in uplink mode

trunk port has been probed (Fl mode), but the problema is the same the mds not see the wwwn of the vhba.

Thanks

[Rick1776]

So the FI's are running NPV and the MDS has to be running NPIV. Under the interface from the MDS to the FI it would be switchport mode F and you have to have that interface in the vsan database vsan xxx interface x/x

I've seen this a bunch of times when you have the configuration under the interface itself but not under the vsan database.