Configure Etherchannel on LACP configured module on 6500

[g.weiner]

I setup a blade on my 6513 to use lacp for my SAN using the channelprotocol command. I now

need to setup an Etherchannel on the same blade between 4 ports but I get the error that it is configured as LACP. Is there any way to set specific

ports back to pagp so I can setup an etherchannel on these ports or do they need to go on a separate blade. I need etherchannel v.s. LACP because VMware ESX doesn't support LACP.

Thanks

Greg

[Lei Tian]

Hi Greg,

If the 6500 is running native mode, you can configure lacp or pagp per port base.

HTH

Lei Tian

[g.weiner]

How can I determine that? The 6513 is running CATOS

[Lei Tian]

If you are running CATOS, then it is not native mode. In catos, you cannot have different protocols running on same module.

HTH,

Lei Tian