Configuring SNMP Version 3

[ALIAOF_]

I am trying to setup SNMP v3 on a 4948E switch here is what I have done so far:

snmp-server location "location"

snmp-server contact IT Admins

snmp-server group SNMPgrp v3 priv read SNMP-ro write SNMP-rw access 80

snmp-server user snmp_user SNMPgrp v3 auth sha xxxxxxxxx priv aes 128 xxxxxxxx access 80

What else am I missing and how can I confirm that it is configured correctly?

[kushtrim dautaga]

Hi Mohammad

You also need to specify :

snmp-server view "nameofview" "MIB view family name" included

snmp-server host x.x.x.x (snmp server ip address) version 3 auth "specify your user"

Regards

[singhaam007]

Hi Mohammad,

you can try something like this

snmp-server community RO  --its good to use RO access not RW

snmp-server location

snmp-server contact

snmp-server enable traps snmp authentication linkdown linkup coldstart warmstart

snmp-server enable traps transceiver all

snmp-server enable traps tty

snmp-server enable traps cluster

snmp-server enable traps cpu threshold

snmp-server enable traps vtp

snmp-server enable traps port-security

snmp-server enable traps envmon fan shutdown supply temperature status

snmp-server enable traps storm-control trap-rate 100

snmp-server enable traps power-ethernet group 1

snmp-server enable traps power-ethernet police

snmp-server enable traps fru-ctrl

snmp-server enable traps syslog

snmp-server enable traps mac-notification change move threshold

snmp-server enable traps errdisable

snmp-server host ver 3 auh< password>

snmp-server host ver 3 auh< password>

hope this will help.

please rate if this helps.

thanks