i am trying to configure my HP 420 access point. I have configure different SSID on it,
This access point is connected to cisco 4500 switch, i have configure trunk on up link to access point.
my problem is the client are not able to get an IP address form the correct vlan if i tagged the SSID to it.
=========
in the following the output of show run int in cisco 4500 switch:
interface GigabitEthernet3/13
description ==== HP ACCess point ====
switchport trunk allowed vlan 99,130,132
switchport mode trunk
switchport nonegotiate
her is the HP Access point configuration
HP ProCurve Access Point 420#sh system
System Information
============================================================
Serial Number : AP Ser
System Up time : 0 days, 0 hours, 31 minutes, 34 seconds
System Name : OT1
System Location :
System Contact : Contact
System Country Code : OM - OMAN
MAC Address : AP Mac
IP Address : AP IP add
Subnet Mask : 255.255.255.0
Default Gateway : 10.78.99.1
VLAN State : ENABLED(Static VLAN ID)
Management VLAN ID(AP): 99 (T)
IAPP State : ENABLED
DHCP Client : DISABLED
HTTP Server : ENABLED
HTTP Server Port : 80
HTTPS Server : DISABLED
HTTPS Server Port : 443
Slot Status : 802.11g
Radio Status : Enabled
Software Version : v2.1.5
SSH Server : DISABLED
SSH Server Port : 22
Telnet Server : ENABLED
Max Telnet Session : 4
Serial Port : ENABLED
Reset Button : ENABLED
SSID Number Supported : 8
============================================================
