Connecting 2 locations with 2 lines

[Anand Narayana]

Hi,

on Location A 3750 & on location B3com layer 3 switch, A & B are connected with two 2 Mbps leased line with ethernet output, now i wanted to load balance or i wanted to use a etherchannel kind of thing, so that even if 1 link goes, the other should still be up & running. how do i proceed.

3750------3com ---connected via ISP1

3750------3com ---connected via ISP2 to the same location. it is a point-to-point link.

[Amit Singh]

Anand,

CEF is by default enabled on the 3750 switches.It only supports hardware per destination switching bydefault. If you want to configure it for sw per-packet load-balancing, try configuring " ip load-sharing per-packet " under the L3 interfaces.

HTH,

-amit singh