Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Recently I upgraded ISE VM from 3.2 patch4 to 3.3. After the upgrade, I was unable to access both CLI and GUI. GUI it does not open where as the CLI, soon after I enter the login credentials, it accepts and prompt again for the login. Multiple reboot...
Hi,
I have Cisco 1602 AP. I am planning to have the wireless users connected to this AP so that when they access Internet, it should prompt them to enter the user name and password on their web browser. This is is similar to Captive Portal but i wan...
Hi, I am looking for a equivalent command of 'nat (inside) 0 access-list zerononat' in ASA 9.1(2) for my vpn configuration. Currently I have the access list configurated but stuck without knowing the nonat access-list zerononat extended permit ip ...
Hi, I have Cisco 5515 IOS 9.1(2). I had configured out-to-in rule with 'ssh' and able to access the Internet server, but the same server is unable to access the Internet. Not sure what i am missing here. Please look in to the configuration below and...
Hi, Here is the scenario, my laptop is assigned with an IP 172.16.1.1 and MAC address is 'abcd.efgh.ijkl'. Now is there a way that if a different MAC address '1234.5678.9012' assigned my IP 172.16.1.1, when i am not available in the ofifce, it should...
Login Loop, I have attached the screen shot. I enter the login credentials (Login.jpg), it accepts and then prompts me to login again (Post_login.jpg). There is no authentication error message. I have attached a sample authentication error message (A...
Hi, I found the equivalent command of 'nat (inside) 0 access-list zerononat' after a multiple trail and errors.Below the command that i used and it did the magic. nat (inside,any) source static 172.16.18.0 172.16.18.0 destination static 172.16.254....
