Hi,
im trying to make a local network with GNS3.
im using NAT and static routing to connect network 192.168.10.0 and 192.168.137.0.
the R1 can connect to internet and able to ping any IP, but the PC1 cant even ping the cloud.
here's my config.
R1#config
Configuring from terminal, memory, or network [terminal]?
Enter configuration commands, one per line. End with CNTL/Z.
R1(config)#int fa0/0
R1(config-if)#no sh
R1(config-if)#
*Mar 1 00:01:22.059: %LINK-3-UPDOWN: Interface FastEthernet0/0, changed state to up
*Mar 1 00:01:23.059: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0, changed state to up
R1(config-if)#ip add dhcp
R1(config-if)#ip nat outside
R1(config-if)#
*Mar 1 00:01:45.323: %LINEPROTO-5-UPDOWN: Line protocol on Interface NVI0, changed state to up
R1(config-if)#exit
R1(config)#int fa1/0
R1(config-if)#no sh
R1(config-if)#ip add 192.
*Mar 1 00:01:58.875: %LINK-3-UPDOWN: Interface FastEthernet1/0, changed state to up
*Mar 1 00:01:59.875: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet1/0, changed state to up
R1(config-if)#ip add 192.168.10.1 255.255.255
*Mar 1 00:02:40.071: %DHCP-6-ADDRESS_ASSIGN: Interface FastEthernet0/0 assigned DHCP address 192.168.137.37, mask 255.255.255.0, hostname R1
R1(config-if)#ip add 192.168.10.1 255.255.255.0
R1(config-if)#ip nat inside
R1(config-if)#exit
R1(config)#ip nat inside source static 192.168.10.2 192.168.137.2
R1(config)#ip nat outside source static 192.168.137.1 192.168.10.10
R1(config)#ip route 192.168.10.2 255.255.255.255 192.168.137.1
im sharing the internet from my wi-fi to host-only adapter and i can ping R1 from my cmd-prompt.
Do you have any suggestion to solve this problem?
