console framing error

[kristiant]

When i boot up my 1720 router i get this message: console framing error

and i cant enter the cli but pressing break to enter rommon works

Any ideas

Kristian

[Giuseppe Larosa]

Hello Kristian,

verify the console cable you are using on another device it could be faulty

verify your serial port settings

they should be 9600 bps 8 bit 1 bit stop no parity flow control none

try to telnet to the router instead of sending it in ROMMON (you may need a cross-over ethernet RJ45 cable)

Hope to help

Giuseppe

[kristiant]

after searcing awile on the net i probaly found the solution. The problem isnt the cable ore the connection setting on the port

but rather that i use a x64 and a usb-serial adapter. Booted up an old xp pc and i worked straith away

[Giuseppe Larosa]

Hello Kristian,

interesting to know that Windows XP 64 bit + usb to rs232 adapter can be a problem for console connections to cisco routers

Best Regards

Giuseppe

[kristiant]

after some further diging i found out this isnt the x64 os same thing happend when i used the rs232 adapter in the old Pc, when i got it working i just used the com port and not the adapter, sry being abit in the rush there to blame the os ;). But its not the adapter itself to blame either since i use it to configure several types of alarm systems and Nortel switches whitout any issue