Cooper test / no port selection possible

[maciej.berghof]

Hi all,

I've got a brand new SG200-18 and wanted to use the build-in diagnostics to test my cables.

When I go to: Administration -> Diagnostics -> Cooper Test   ... there is a Pull-down menu to select a port on which to run the cooper test.  The issue is that this pull-dowm menu is EMPTY!  

So what's wrong here?

BTW: the most recent Firmware is already installed (1.4.5.02) and there are no dangerous entries in the log

[Leo Laohoo]

That sounds like a bug with the firmware.

[maciej.berghof]

Yes and no. I found it now. Cisco does not support Safari 10 browser. What a shame!

It works with FireFox on my Mac.