01-11-2007 06:30 AM - edited 03-05-2019 01:43 PM
I have a 2960 where i have created a base config file, i have 20 switches using similar config,only ip,gateway and hostname changes to be made.I copied and pasted but the commnads dont work well, any suggestions.Like the command xmodem hoto ..thanks
01-11-2007 09:32 AM
Could be that the copy and paste is happening too fast for the switch to process it. Try using a telnet/ssh client that allows you to use character and line delays. SecureCRT allows this.
01-11-2007 01:26 PM
Hi
I use a very short config to enable the switches to communicate with my laptop using IP (add an IP address to VLAN 1 and enable one port) and then copy the config files via tftp to the startup config.
Good luck :-)
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide