08-17-2022 09:11 PM - edited 08-18-2022 02:09 AM
Hi
I can't ping from PC2 to PC0 also I can't ping from PC2 to PC1
THANKS
08-17-2022 11:15 PM
Hello,
post your zipped Packet Tracer project (.pkt) file...
08-19-2022 11:58 PM
Hi
you didn't answer me
thanks
08-18-2022 04:42 AM
Unable to open your Zip file attached again additionly you can check the below points.
1-configure Intervlan routing on the L3 Switch for PC0 to PC1 communication.
2- for the PC2 Reachability you have to check the route on the switch default IP route 0.0.0.0 0.0.0.0 ( Fa0/3 IP )
3- add reverse route on the router.
2.
08-18-2022 05:36 PM
there are no routes to reach networks; 2 static routes are wrong on your Router while L3 switch does not have any static routes; Also, IP interface in the 192.168.3.x /24 is missing on L3 switch. How can router talks to L3 switch ? you need to add IP to interface vlan x and vlan x into database or make Fa0/3 not switchport but routeable interface (no switchport)
Syntax for static route command is destination network, destination mask, which way to go ? , i.e.
ip route 192.168.1.0 255.255.255.224 ( my exit interface or my next hop IP)
Regards, ML
**Please Rate All Helpful Responses **
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide