03-19-2014 01:05 AM - edited 03-07-2019 06:46 PM
hi,
We need to configure the NAT as per the below requirement.
source ip 10.1.1.5 /24
destination ip 172.20.0.10
Now the source(10.1.1.5 ) will sent the packet to destination (172.20.0.10).
If only 10.1.1.5 sents packet to the 172.20.0.10 the destination should change to 10.5.0.10. ( 172.20.0.10 =>10.5.0.10 if source is 10.1.1.5 ).
Rest traffic should flow normally.
Kindly suggest any configuration.
Regards
Pushpak
03-19-2014 04:34 AM
Hi,
May i know where you want to configure NAT? router/firewall??
Regards,
Satya.M
03-19-2014 10:47 PM
Hi,
We are configuring the NAT on CISCO Router
Regards
Pushpak
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide