DHCP failed. APIPA is being used.

[rwhite123]

I am not sure where I am going wrong.  I posted my configurations that I used as well as the lab.

[rwhite123]

Here is an updated with all green lights (changes Fa0/1-2 to channel-group mode auto). Still having the same issue where PC0, PC1, PC2's DHCP failed. APIPA is being used.

[luis_cordova]

Hello

Try entering these commands in the multilayer switch:

DLS-1(config)# int f0/15

DLS-1(config-if)#sw tr en do

DLS-1(config-if)#sw mo tr

DLS-1(config)#int po 1

DLS-1(config-if)#sw tr en do

DLS-1(config-if)#sw mo tr

In ALS_1 switch:

ALS_1(config)#int po 1

ALS_1(config-if)#sw mo tr

ALS_1(config)#int po 3

ALS_1(config-if)#sw mo tr

In ALS#2 switch:

ALS#2(config)#int po 2

ALS#2(config-if)#sw mo tr

ALS#2(config#int po 3

ALS#2(config-if)#sw mo tr

Regards