Hello Cisco Community !
I'm currently in school working on a project. To summarize it, I need to connect DHCP Clients on two Catalyst 2960 on a Vlan. These 2960s are connected to a 3560-E (Layer 3 Switch) by a trunk connection. This L3 is connected to a Router 1921.
I think that my configs are OK, but I'm scrathing my head still because when I connect in SHCP on my access switches, I get an address but I can't get internet, I can ping the Core Switch but not the Router.
I will link my config files after this.
The router is connected to internet by 192.168.40.167
The router is connected to core switch by 172.17.2.254
The core is connected to router by 172.17.2.253
The core in trunking 4 VLANS :
VLAN2 = "Vlan_Interne" with 172.17.2.253 /24
VLAN10 = "Serveur_Web" with 172.17.10.14 /28
VLAN20 = "Serveur_Minux" with 172.17.20.14 /28
VLAN50 = "Vlan_Clients" with 172.17.51.254 /23
If anyone has any ideas, it would be so nice !
Thx !
