Does 6509E VSS still support custom queuing?

[huanincanada]

We are ready for Nortel PBX migration. It was connected to Cisco 3600 router with custom queuing such as the following command:

queue-list 1 protocol ip 1 udp 20480
queue-list 1 protocol ip 2 udp 20482
queue-list 1 default 3

int f0/0

custom-queue-list 1

in future, we will move the connection to 6509E-VSS-720(IOS 12.2(33)). I am able to put "queue-list 1...." command in, but it failed when I appied "custom-queque-list 1" with interface. Could anybody let me know if 6509E does not support custom queuing? or is there any other commands for it?? Thanks a lot!

[Joseph W. Doherty]

Disclaimer

The Author of this posting offers the information contained within this posting without consideration and with the reader's understanding that there's no implied or expressed suitability or fitness for any purpose. Information provided is for informational purposes only and should not be construed as rendering professional advice of any kind. Usage of this posting's information is solely at reader's own risk.

Liability Disclaimer

In no event shall Author be liable for any damages whatsoever (including, without limitation, damages for loss of use, data or profit) arising out of the use or inability to use the posting's information even if Author has been advised of the possibility of such damage.

Posting

6500 have a much more limited QoS feature set than ISR routers.  Also, 6500 QoS features vary per line card.

I.e. unlikely you can just use a same/similar config, but you might be able to construct something that provides a similar result.