I am trying to configure spanning-tree mode MST on a 3845 with an intergrated switch module. However, it will not accept the command. What am I missing?
The hardware configuration of the router is listed below.
STL260LL-AJ19RTR6 uptime is 24 weeks, 1 day, 18 hours, 18 minutes
System returned to ROM by power-on
System image file is "flash:c3845-advipservicesk9-mz.124-5b.bin"
This product contains cryptographic features and is subject to United
States and local country laws governing import, export, transfer and
use. Delivery of Cisco cryptographic products does not imply
third-party authority to import, export, distribute or use encryption.
Importers, exporters, distributors and users are responsible for
compliance with U.S. and local country laws. By using this product you
agree to comply with applicable laws and regulations. If you are unable
to comply with U.S. and local laws, return this product immediately.
A summary of U.S. laws governing Cisco cryptographic products may be found at:
http://www.cisco.com/wwl/export/crypto/tool/stqrg.html
If you require further assistance please contact us by sending email to
export@cisco.com.
Cisco 3845 (revision 1.0) with 483328K/40960K bytes of memory.
Processor board ID FTX0921C0JD
4 FastEthernet interfaces
2 Gigabit Ethernet interfaces
4 Channelized T1/PRI ports
2 Channelized (E1 or T1)/PRI ports
2 Virtual Private Network (VPN) Modules
DRAM configuration is 64 bits wide with parity enabled.
479K bytes of NVRAM.
250880K bytes of ATA System CompactFlash (Read/Write)
Configuration register is 0x2102
Thanks,
Steve