I have a nexus 3548 with the standard 24port license. Does this switch support QinQ dot1q-tunnel mode for a switchport interface?
I have the commands present and the cli guide for nx-os ver 6.0 show the commands also. But if i try to execute a dot1-tunnel mode I'm prompt with the following error.
SW2(config-if)# switchport mode dot1q-tunnel
ERROR: Ethernet1/2: requested config change not allowed
The port is setup as switchport, no cdp and spanning-tree type edge. Any ideals or is this like some of the other feartures that are listed in the command set but not really applicable on the 3548s