08-29-2013 01:24 AM - edited 03-07-2019 03:11 PM
Hi All,
I met a duplex mismatch issue in our new DC.
The port configuration on the N7k and controller is the same as in other DC
Only difference is version of the NxOS on the N7k.
On N7k 5.2(1) works
On N7k 5.2(7) i get below logs :
2013 Aug 21 22:23:24 xxx %CDP-4-DUPLEX_MISMATCH: Duplex mismatch discovered on Ethernet10/8, with LAGInterface0/3/1
2013 Aug 21 22:24:24 xxx last message repeated 8 times
2013 Aug 21 22:25:24 xxx last message repeated 8 times
2013 Aug 21 22:27:24 xxx last message repeated 16 times
2013 Aug 21 22:29:24 xxx last message repeated 16 times
Port configuration :
interface Ethernet10/8
description WLC 5508-1
switchport
switchport mode trunk
switchport trunk native vlan 50
switchport trunk allowed vlan 50,500,570
spanning-tree port type edge trunk
channel-group 1100
no shutdown
xxx# sh int e 10/8
Ethernet10/8 is up
Dedicated Interface
Belongs to Po1100
Hardware: 10/100/1000 Ethernet, address: 0006.f6b1.d2f7 (bia 0006.f6b1.d2f7)
Description:WLC 5508-1
MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA
Port mode is trunk
full-duplex, 1000 Mb/s
Controller 5508 version 7.3.112.0
Controller ports :
Port Summary
STP Admin Physical Physical Link Link
Pr Type Stat Mode Mode Status Status Trap POE SFPType
-- ------- ---- ------- ---------- ---------- ------ ------- ------- ----------
1 Normal Forw Enable Auto 1000 Full Up Enable N/A 1000BaseTX
2 Normal Forw Enable Auto 1000 Full Up Enable N/A 1000BaseTX
3 Normal Forw Enable Auto 1000 Full Up Enable N/A 1000BaseTX
4 Normal Forw Enable Auto 1000 Full Up Enable N/A 1000BaseTX
How can i fix this issue ? Ports are set up and show the same - 1000 / Full
the messages are annoying as loggs are almost full of them.
Thank you in advance
11-27-2013 11:24 AM
Radoslaw,
Did you ever receive an answer to your question? If you know how to fix this issue, can you let me know? We are experiencing the same issue in our environment.
Regards,
Matt Yoder
11-27-2013 12:12 PM
Hi Matthew,
The issue is related to bug -> "CDP duplex mismatch when using LAG on 5508 & 8510 WLC” (CSCuc94082)
The fastest way to solve (workaround) this is disable cdp on the controller by executing following command: config cdp advertise-v2 disable
Hope this helped you
Regards,
Radek
02-05-2019 04:35 AM
02-05-2019 04:46 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide