04-02-2014 01:17 PM - edited 03-07-2019 06:58 PM
Hello Cisco Team,
We have the following request from our production IT Team:
WE have certain production devices that are plug into our CISCO Switches such as PLC or Video Cameras. The question is it possible to assign these devices a dymamic IP based on the Port they plug into, the idear is that if a devices dies a production worker can switch out the devices. FOr the production it is curical that they obtain the same IP Address, therefore the question is it possible to setup dynamic/manual DHCP based on the MAC Address of the CISCO Port versus the MAC Address of the device?
Thanks
Christian
04-02-2014 03:22 PM
Not possible, as far as I'm aware.
04-02-2014 03:24 PM
If the devices are in the same vlan, DHCP will do his job. If not check VLAN Management Policy Server (VMPS)
04-02-2014 11:56 PM
Hi,
This is possible but I don't know if it is implemented on all switch models.
you should take a look in Cisco feature navigator for this.I've just verified and it is available on 2960S-2960X-2960C and on 3560/3750.
Regards
Alain
04-07-2014 06:33 AM
Yes,
You need to have a LANBASE IOS software image. It is not supported on LANLITE IOS software image.
Regards,
XLG
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide