cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
627
Views
0
Helpful
1
Replies

Etherchannel

MK31
Level 1
Level 1

If I am creating an EtherChannel between the access switch and the Multilayer switch, does the mode needs to be the same?

1 Accepted Solution

Accepted Solutions

Mark Elsen
Hall of Fame
Hall of Fame

 

 - No , but you may leave one end in mode desirable (for 'parent') and the other default (should work) , if not check this document for further options : https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst4500/12-2/31sga/configuration/guide/config/channel.pdf mode on , usually applies to different vendor solutions.

 M.



-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
    When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '

View solution in original post

1 Reply 1

Mark Elsen
Hall of Fame
Hall of Fame

 

 - No , but you may leave one end in mode desirable (for 'parent') and the other default (should work) , if not check this document for further options : https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst4500/12-2/31sga/configuration/guide/config/channel.pdf mode on , usually applies to different vendor solutions.

 M.



-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
    When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '