failover

[jigz.bagsicjr]

Hi,

I'm a little bit confused with the approach on how to get a failover with my current set-up.

From my attachment I want all my traffic will pass to primary router and split the internet traffic going to secondary router 3800 and my private corporate traffic will be taking the mpls serial 0/1/1. And it will also make a failover that all traffic to the secondary router when primary router fails. I'm using L3 switch where 2 routers are connected.

What is the best approach for this one?

Note: I have a tunnel from secondary router to pass my private corporate network.

a) Do i need to use HSRP?

b) Do i need to use dynamic local routing like EIGRP?

c) etc???

Please show me on how to start with the config.

Thanks!

[yassine-m]

Hi,

To help you I need the routing policy you choose. For me the traffic should pass through the L3 switch even if it comes from the MPLS router going to the Internet.

Br

[jigz.bagsicjr]

Hi,

so far i haven't yet started to make a draft of config. im hoping to get somewhat a thoughts on the best approach.

Thanks!